LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2013 >> Matrix Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Engine Control System (2AZ-FE) (Service Information)) >> Camshaft Position Sensor >> Removal >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Camshaft Position Sensor: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 11
  2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE  See step  3
  3. REMOVE CAMSHAFT POSITION SENSOR 
    1. Disconnect the camshaft position sensor connector.
      Fig 1: Locating Camshaft Position Sensor Bolt
      GTY178911Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and the camshaft position sensor.
scientia non olet · About LEMON Manuals