Fuel Sender Gauge Assembly: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL FUEL SENDER GAUGE ASSEMBLY
1. Install the fuel sender gauge assembly by sliding it downward.
  
  Fig 1: Identifying Fuel Sender Gauge Assembly (2WD)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Do not damage the wire harness.
2. Connect the connector of the fuel sender gauge assembly.
  NOTE:
  Make sure that the fuel sender gauge arm does not bend.
INSTALL FUEL SUCTION TUBE ASSEMBLY
1. Install the fuel suction tube assembly to the fuel tank assembly. Refer to INSTALLATION .
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT FOR FUEL LEAK . Refer to ON-VEHICLE INSPECTION - Step 1