Inspection Procedure

NOTE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.
When replacing the door control and tire pressure monitoring system receiver assembly, read the transmitter IDs (tire pressure warning system) stored in the old ECU using the Techstream and write them down before removal. Refer to REGISTRATION .
It is necessary to perform initialization. Refer to INITIALIZATION after registration. Refer to REGISTRATION of the transmitter IDs into the door control and tire pressure monitoring system receiver assembly if the door control and tire pressure monitoring system receiver assembly has been replaced.
When replacing or inspecting the door control and tire pressure monitoring system receiver assembly and wire harness, do not change the position or length of the wire harness. If the wire harness is too close to the door control and tire pressure monitoring system receiver assembly, wireless function performance may be affected.