Key-off Operation Function Operates even if Operating Conditions are not Satisfied: Procedure

1. Check that the manual up and down functions using the power window regulator master switch assembly and power window regulator switch assembly can operate all the power windows. Refer to OPERATION CHECK .

   OK

   Manual up and down functions are normal.

NG → See step   9 

OK: Go to next step 

1. Check that the remote up and down functions using the power window regulator master switch assembly can operate all the power windows. Refer to OPERATION CHECK .

   OK

   Remote up and down functions are normal.

NG → See step   9 

OK: Go to next step 

1. Check the power window operation function after the ignition switch is turned off.

   Result

   Result	Proceed to
   Power window can still be operated even after opening driver door or front passenger door within approximately 43 seconds of ignition switch being turned off	A
   Power window can still be operated even after approximately 43 seconds have elapsed after ignition switch is turned off (for All Doors)	B
   Power window can still be operated even after approximately 43 seconds have elapsed after ignition switch is turned off (for Driver Door)	C
   Power window can still be operated even after approximately 43 seconds have elapsed after ignition switch is turned off (Front Passenger Door, Rear LH Door* or Rear RH Door*)	D

   • *: w/ Rear Power Window

B → See step   8 

C → See step   10 

D → See step   5 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Main Body / Data List.
5. Read the Data List according to the display on the Techstream.
   MAIN BODY
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   FR Door Courtesy SW	Front door courtesy light switch RH / ON or OFF	OFF: Front door RH closed ON: Front door RH open	-
   FL Door Courtesy SW	Front door courtesy light switch LH / ON or OFF	OFF: Front door LH closed ON: Front door LH open	-

   OK

   On the Techstream screen, ON or OFF is displayed accordingly.

NG → See step   7 

OK → See step   8 

1. Replace the main body ECU (multiplex network body ECU). Refer to REMOVAL .

NEXT: Go to next step 

1. Check the power window operation function after the ignition switch is turned off.

   OK

   The power window control system operates normally.

NG → See step   11 

OK → END (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) WAS DEFECTIVE)