Power Source Mode does not Change to ON (ACC): Procedure

CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) See step 3
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: Go to next step
INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY See step 4
NG → See step 4

OK: Go to next step
INSPECT POWER MANAGEMENT CONTROL ECU See step 5
NG → See step 5

OK → CHECK RELAY CONTACT SIDE CIRCUIT
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY. Refer to REMOVAL
REPLACE POWER MANAGEMENT CONTROL ECU. Refer to REMOVAL