Radio Receiver: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY
INSTALL EXTENSION MODULE (w/ Navigation System) . Refer to INSTALLATION - Step 1
INSTALL NO. 2 RADIO BRACKET
1. w/o Navigation System:
  1. Install the No. 2 radio bracket with the 3 bolts.
2. w/ Navigation System:
  1. Install the No. 2 radio bracket with the 5 bolts.
INSTALL NO. 1 RADIO BRACKET
1. w/o Navigation System:
  1. Install the No. 1 radio bracket with the 3 bolts.
2. w/ Navigation System:
  1. Install the No. 1 radio bracket with the 5 bolts.
INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
1. Connect each connector.
2. Engage the 4 claws.
3. Install the radio and display receiver assembly with bracket with the 4 bolts.
INSTALL UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 27
INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH . Refer to INSTALLATION - Step 28
INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 30
INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY . Refer to INSTALLATION - Step 31
CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
INSTALL REAR NO. 3 FLOOR BOARD UPPER PLATE . Refer to INSTALLATION - Step 3
INSTALL DECK FLOOR BOX RH . Refer to INSTALLATION - Step 4
INSTALL REAR NO. 3 FLOOR BOARD . Refer to INSTALLATION - Step 55