DCM(Telematics Transceiver): Removal: Removal
WARNING: This page is about a different variant/trim than selected.
- REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY . Refer to REMOVAL - Step 6
- REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY . Refer to REMOVAL - Step 7
- REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH . Refer to REMOVAL - Step 9
- REMOVE UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY . Refer to REMOVAL - Step 10
- REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System) . Refer to REMOVAL - Step 10
- REMOVE NAVIGATION RECEIVER WITH BRACKET (w/ Navigation System) . Refer to REMOVAL - Step 10
- REMOVE BACK-UP BATTERY WITH BRACKET See step 7
- REMOVE DCM (TELEMATICS TRANSCEIVER) WITH BRACKET
- Disconnect the 3 connectors.
- Remove the 3 bolts and DCM (telematics transceiver) with bracket.
- REMOVE NO. 2 TELEPHONE BRACKET
- Remove the 2 screws and No. 2 telephone bracket.
- REMOVE NO. 1 TELEPHONE BRACKET
- Remove the 2 screws and No. 1 telephone bracket.
- REMOVE DCM (TELEMATICS TRANSCEIVER)