DTC B1796: Sleep Operation Failure of Occupant Classification ECU: Procedure

REPLACE OCCUPANT DETECTION ECU
1. Turn the power switch off.
2. Disconnect the cable from the negative (-) auxiliary battery terminal.
3. Replace the occupant detection ECU. Refer to REMOVAL .
4. Connect the cable to the negative (-) auxiliary battery terminal.
NEXT: Go to next step
PERFORM ZERO POINT CALIBRATION
1. Using the Techstream, perform Zero Point Calibration. Refer to INITIALIZATION .
NEXT: Go to next step
PERFORM SENSITIVITY CHECK
1. Using the Techstream, perform Sensitivity Check. Refer to INITIALIZATION .
NEXT → END