LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2013 >> Prius Plug-in >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 100 (Lighting System (Diagnostics & Circuit Tests) (Except Plug-In)) >> Lighting System >> Customize Parameters >> Customize Parameters
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Customize Parameters

WARNING: This page is about a different variant/trim than selected.
  1. CUSTOMIZING FUNCTION WITH TECHSTREAM 

    HINT: 

    The following items can be customized.

    NOTE:
    • When the customer requests a change in a function, first make sure that the function can be customized.
    • Be sure to make a note of the current settings before customizing.
    • When troubleshooting a function, first make sure that the function is set to the default setting.
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Customize Setting / Illuminated Entry.
    5. Select the setting by referring to the table below.
      ILLUMINATED ENTRY

      Tester Display Default Content Setting Relevant ECU
      Lighting Time 15 s Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (ACC or IG).) 7.5 s, 15 s or 30 s Main body ECU (Multiplex network body ECU)
      I/L when ACC OFF ON Lights up power switch illumination, front interior lights, rear interior light and footwell lights when the power switch is turned from on (ACC or IG) to off. ON or OFF
      I/L ON W/Door Key Unlock ON Lights up power switch illumination, front interior lights, rear interior light and footwell lights when doors are unlocked using a mechanical key or door control transmitter. ON or OFF
      Light Control ON Dims (ON setting) or turns off (OFF setting) the footwell lights under the following conditions:
      Power switch on (IG), shift lever not in P, and all doors closed.      		 ON or OFF
      Room Light when Aprchd ON Lights up the power switch illumination, front interior lights, rear interior light and footwell lights when a key enters any actuation area around the doors. ON or OFF
      Inside Foot Light ON ON/OFF of footwell light control function. ON or OFF
  2. CUSTOMIZING FUNCTION WITH MULTI-DISPLAY (w/ Navigation System (for Navigation Receiver Type) or w/ Audio and Visual System (w/o Daytime Running Light)) 

    HINT: 

    The following items can be customized.

    NOTE:
    • When the customer requests a change in a function, first make sure that the function can be customized.
    • Be sure to make a note of the current settings before customizing.
    • When troubleshooting a function, first make sure that the function is set to the default setting.
    1. Turn the power switch on (IG).
    2. Enter the following menus: Setup / Vehicle / Vehicle Customization / Light Settings.
    3. Select the setting by referring to the table below.
      LIGHT SETTINGS

      Display Default Content Setting Relevant ECU
      Interior Lights Off Timer 15 sec. Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (ACC or IG).) Off, 7.5 sec., 15 sec., or 30 sec. Main body ECU (Multiplex network body ECU)
scientia non olet · About LEMON Manuals