Cruise Main Indicator Light Circuit: Procedure
WARNING: This page is about a different variant/trim than selected.
- PERFORM ACTIVE TEST USING TECHSTREAM
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Check the cruise main indicator light by performing Active Test.COMBINATION METER
Tester Display Test Part Control Range Diagnostic Note Indicat. Lamp Cruise Cruise main indicator light
(Constant speed control mode)OFF or ON Confirm that the vehicle is stopped with engine idling Indicat. Radar Cruise Cruise main indicator light
(Vehicle-to-vehicle distance control mode)OFF or ON Confirm that the vehicle is stopped with engine idling OK
The display changes in accordance with Active Test operation.
NG → See step 4
OK: Go to next step
- READ VALUE USING TECHSTREAM
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Radar Cruise / Data List.
- Check the Data List for proper functioning of the cruise main indicator light.RADAR CRUISE
Techstream Display Measurement Item/Range Normal Condition Diagnostic Note Cruise Control Main Switch Cruise control switch signal / ON or OFF ON: Main switch on
OFF: Main switch off- OK
When the cruise control main switch is operated, the display changes in accordance with switch operation.
NG → See step 5
OK → See step 3
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE
- REPLACE NO. 3 METER CIRCUIT PLATE. Refer to DISASSEMBLY
- REPLACE DRIVING SUPPORT ECU. Refer to REMOVAL