Cruise SET Indicator Light Circuit: Procedure
WARNING: This page is about a different variant/trim than selected.
- PERFORM ACTIVE TEST USING TECHSTREAM
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Check the SET indicator light by performing the Active Test.COMBINATION METER
Tester Display Test Part Control Range Diagnostic Note Indicat. SET SET indicator light OFF or BLINK - OK
The SET indicator light blinks or goes off according to Techstream operation.
NG → See step 4
OK: Go to next step
- READ VALUE USING TECHSTREAM
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Radar Cruise / Data List.
- According to the display on tester, read the Data List.RADAR CRUISE
Tester Display Measurement Item/Range Normal Condition Diagnostic Note SET/COAST Switch - SET switch signal / ON or OFF ON: - SET switch on
OFF: - SET switch off- OK
The display changes as shown above according to cruise control main switch operation.
NG → See step 5
OK → See step 3
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE
- REPLACE NO. 3 METER CIRCUIT PLATE. Refer to DISASSEMBLY
- REPLACE DRIVING SUPPORT ECU. Refer to REMOVAL