Headlight Cleaner Motor and Relay Circuit: Procedure

HINT: 

The following check should be performed with the headlight cleaner motor and pump assembly installed to the washer jar.

1. Fill the washer jar with washer fluid.
2. Connect a battery positive (+) lead to terminal 2 of the headlight cleaner motor and pump assembly, and a battery negative (-) lead to terminal 1.
   Fig 1: Identifying Headlight Cleaner Motor And Pump Assembly Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Check that washer fluid flows from the washer jar.

   OK

   Washer fluid is pumped from the washer jar.

   TEXT IN ILLUSTRATION
   
   

   *1	Component without harness connected (Headlight Cleaner Motor and Pump Assembly)

NG → See step   4 

OK: Go to next step 

1. Connect the headlight cleaner motor and pump assembly connector.
2. Disconnect the A44 headlight cleaner control relay connector.
   Fig 2: Identifying Harness And Connector (Headlight Cleaner Motor Circuit)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   A44-6 (PB) - Body ground	Always	11 to 14 V

   TEXT IN ILLUSTRATION
   
   

   *1	Front view of wire harness connector (to Headlight Cleaner Control Relay)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR (HEADLIGHT CLEANER CONTROL RELAY - BATTERY) 

OK → See step   3