Navigation Receiver: Installation: Installation

PRECAUTION
NOTE:
When installing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.
INSTALL NAVIGATION ECU SUB-ASSEMBLY
INSTALL HARD DISK DRIVE See step 2
INSTALL NO. 2 RADIO BRACKET
1. Install the No. 2 radio bracket with the 4 screws.
INSTALL NO. 1 RADIO BRACKET
1. Install the No. 1 radio bracket with the 4 screws.
INSTALL NAVIGATION RECEIVER WITH BRACKET
1. Engage the 4 claws and temporarily install the navigation receiver with bracket as shown in the illustration.
  
  Fig 1: Identifying Navigation Receiver With Bracket Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the navigation receiver with bracket with the 4 bolts.
INSTALL UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 27
INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH . Refer to INSTALLATION - Step 28
INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 30
INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY . Refer to INSTALLATION - Step 31
CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
INSTALL REAR NO. 3 FLOOR BOARD . Refer to INSTALLATION - Step 58
INSTALL REAR DECK FLOOR BOX . Refer to INSTALLATION - Step 59
INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) . Refer to INSTALLATION - Step 60
INSPECT HARD DISK DRIVE
Refer to OPERATION CHECK