Data List / Active Test

WARNING: This page is about a different variant/trim than selected.

DATA LIST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.

Read the Data List according to the display on the Techstream.

MAIN BODY

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
Communication D-Door Motor	Connection status between power window regulator motor assembly (for driver side) and main body ECU (multiplex network body ECU)/OK or STOP	OK: Connected STOP: Not Connected	DTC is output if an error occurs in LIN communication.
Communication P-Door Motor	Connection status between power window regulator motor assembly (for front passenger side) and main body ECU (multiplex network body ECU)/OK or STOP	OK: Connected STOP: Not Connected	DTC is output if an error occurs in LIN communication.
Communication RR-Door Motor	Connection status between power window regulator motor assembly (for rear RH side) and main body ECU (multiplex network body ECU)/OK or STOP	OK: Connected STOP: Not Connected	DTC is output if an error occurs in LIN communication.
Communication RL-Door Motor	Connection status between power window regulator motor assembly (for rear LH side) and main body ECU (multiplex network body ECU)/OK or STOP	OK: Connected STOP: Not Connected	DTC is output if an error occurs in LIN communication.
Communication Master SW	Connection status between multiplex network master switch assembly and main body ECU (multiplex network body ECU)/OK or STOP	OK: Connected STOP: Not Connected	DTC is output if an error occurs in LIN communication.