DTC P0575: Cruise Control Input Circuit: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTC. Refer to DTC CHECK / CLEAR .
5. Perform the following to make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the malfunction cannot be detected.

   1. Drive the vehicle at a speed for which cruise control operation is possible.
   2. Turn the cruise control main switch (ON-OFF button) on.
   3. Push the -SET switch to activate the cruise control.
6. Enter the following menus: Powertrain / Cruise Control / Trouble Codes.
7. Read the DTCs.

   Result

   Result	Proceed to
   DTC is not output	A
   DTC P0575 is output	B

B → See step   3 

A → See step   2