LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2013 >> Prius Two >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Smart Key System (For Entry Function) (Diagnostics - Introduction) (Plug-In)) >> SMART KEY SYSTEM (for Entry Function) >> Data List / Active Test >> Data List / Active Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List / Active Test

WARNING: This page is about a different variant/trim than selected.
  1. DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Smart Key or Main Body / Data List.
    5. Read the Data List according to the display on the Techstream.
      SMART KEY (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) )

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      D-Door Touch Sensor Driver side door touch sensor / ON or OFF ON: Sensor touched
      OFF: Sensor not touched      		 -
      P-Door Touch Sensor Front passenger side door touch sensor / ON or OFF ON: Sensor touched
      OFF: Sensor not touched      		 -
      D-Door Trigger Switch Driver side door lock sensor / ON or OFF ON: Sensor touched
      OFF: Sensor not touched      		 -
      P-Door Trigger Switch* Front passenger side door lock sensor / ON or OFF ON: Sensor touched
      OFF: Sensor not touched      		 -
      Tr/B-Door Lock SW* Back door opener switch assembly (lock switch) / ON or OFF ON: Back door opener switch assembly (lock switch) pushed
      OFF: Back door opener switch assembly (lock switch) not pushed      		 -
      Tr/B-Door Unlock SW* Back door opener switch assembly (opener switch) / ON or OFF ON: Back door opener switch assembly (opener switch) pushed
      OFF: Back door opener switch assembly (opener switch) not pushed      		 -
      Ignition Switch Power switch on (IG) / ON or OFF ON: Power switch on (IG) or hybrid control system started
      OFF: Power switch off      		 -
      Unmatched Vehicle-ID No communication condition between vehicle and key (vehicle-ID) / Yes or No Yes: Key ID code not matched to vehicle
      No: Key ID code matched to vehicle      		 -
      No Response No communication condition between vehicle and key (response) / Yes or No Yes: Key ID code not matched to vehicle
      No: Key ID code matched to vehicle      		 -
      Unmatch Code or Form No communication condition between vehicle and key (response code and format) / Yes or No Yes: Key ID code not matched to vehicle
      No: Key ID code matched to vehicle      		 -
      Key Low Battery Low key battery / Yes or No Yes: Key battery voltage low
      No: Key battery voltage normal      		 -
      Power Save Cnt 10 Min Power save counter - 10 minutes / Min: 0; Max: 255 Within range from 0 to 255 -
      Power Save Cnt 5 Day Power save counter - 5 days / Min: 0; Max: 255 Within range from 0 to 255 -
      Power Save Cnt 14 Day Power save counter - 14 days / Min: 0; Max: 255 Within range from 0 to 255 -
      ID Code Difference(Resp) No communication condition between vehicle and key (ID code) / Yes or No Yes: Key ID code not matched to vehicle
      No: Key ID code matched to vehicle      		 -
      C Code Difference No communication condition between vehicle and key (challenge code) / Yes or No Yes: Key ID code not matched to vehicle
      No: Key ID code matched to vehicle      		 -
      Auto Entry Cancel SW Entry function cancel / ON or OFF Mode status displayed -
      Door Unlock Mode2 Door Unlock Mode / All or Driver Customization status displayed -
      Ignition Available Area Ignition available area / Front or All Customization status displayed -
      Parking Wait Time Parking wait time / 0.5s, 1.5s, 2.5s or 5s Customization status displayed -
      B-Dr Opening Operation* Back door opening operation / Long, Twice or OFF Customization status displayed -
      Touch Activation Over Threshold Consecutive entry lock operation / Active or Not Active Customization status displayed -
      Key Low Battery Warning Low key battery warning / ON or OFF Customization status displayed -
      • *: w/ Entry System Back Door Open Function
      MAIN BODY (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) )

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      ACC SW Power switch on (ACC) / ON or OFF ON: Power switch on (ACC)
      OFF: Power switch off      		 -
      IG SW Power switch on (IG) / ON or OFF ON: Power switch on (IG)
      OFF: Power switch off      		 -
      RR Door Courtesy SW Rear door courtesy light switch signal / ON or OFF ON: Rear door RH or LH open
      OFF: Rear door RH and LH closed      		 -
      RL Door Courtesy SW Rear door courtesy light switch signal / ON or OFF ON: Rear door RH or LH open
      OFF: Rear door RH and LH closed      		 -
      Back Door Courtesy SW Back door courtesy switch signal / ON or OFF ON: Back door open
      OFF: Back door closed      		 -
      Back Door Open Back door lock / Permit or Prohibit Permit: Back door unlocked
      Prohibit: Back door locked      		 -
      Door Lock SW-Lock Front passenger side door control switch lock signal / ON or OFF ON: Lock side of front passenger side door control switch pushed
      OFF: Lock side of front passenger side door control switch not pushed      		 -
      Door Lock SW-Unlock Front passenger side door control switch unlock signal / ON or OFF ON: Unlock side of front passenger side door control switch pushed
      OFF: Unlock side of front passenger side door control switch not pushed      		 -
      Door Key SW-Lock Driver door key-linked lock/unlock switch lock signal / ON or OFF ON: Driver door key cylinder turned to lock position
      OFF: Driver door key cylinder not turned to lock position      		 -
      D Door Key SW-UL Driver door key-linked lock/unlock switch unlock signal / ON or OFF ON: Driver door key cylinder turned to unlock position
      OFF: Driver door key cylinder not turned to unlock position      		 -
      FR Door Lock Pos Front passenger side door lock position switch signal / LOCK or UNLOCK LOCK: Front passenger side door locked
      UNLOCK: Front passenger side door unlocked      		 -
      FR Door Courtesy SW Front passenger side door courtesy light switch signal/ON or OFF ON: Front passenger side door open
      OFF: Front passenger side door closed      		 -
      FL Door Lock Pos Driver door lock position switch signal / LOCK or UNLOCK LOCK: Driver door locked
      UNLOCK: Driver door unlocked      		 -
      FL Door Courtesy SW Driver door courtesy light switch signal/ON or OFF ON: Driver door open
      OFF: Driver door closed      		 -
      RR-Door Lock Pos SW Rear door lock position switch signal / LOCK or UNLOCK LOCK: Rear door RH or LH locked
      UNLOCK: Rear door RH and LH unlocked      		 -
      RL-Door Lock Pos SW Rear door lock position switch signal / LOCK or UNLOCK LOCK: Rear door RH or LH locked
      UNLOCK: Rear door RH and LH unlocked      		 -
  2. ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Smart Key or Main Body / Active Test.
    5. Perform the Active Test according to the display on the Techstream.
      SMART KEY (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) )

      Tester Display Test Part Control Range Diagnostic Note
      Overhead Tuner Power Supply ON Door control receiver ON/OFF -
      MAIN BODY (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) )

      Tester Display Test Part Control Range Diagnostic Note
      Trunk and Back-door Open Back door lock motor ON/OFF -
      Wireless Buzzer Wireless door lock buzzer ON/OFF -
scientia non olet · About LEMON Manuals