Cruise Main Indicator Light Circuit: Procedure
WARNING: This page is about a different variant/trim than selected.
- PERFORM ACTIVE TEST USING TECHSTREAM
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Check the cruise control indicator light by performing Active Test.COMBINATION METER
Tester Display Test Part Control Range Diagnostic Note Indicat. Lamp Cruise Cruise control indicator light
(Constant speed control mode)Cruise control indicator light (Constant speed control mode) OFF or ON - Indicat. Radar Cruise Cruise control indicator light
(Vehicle-to-vehicle distance control mode)Cruise control indicator light (Vehicle-to-vehicle distance control mode) OFF or ON - OK
The display changes in accordance with Active Test operation.
NG → See step 2
OK → See step 3
- REPLACE METER CIRCUIT PLATE NO. 3. Refer to REMOVAL
- REPLACE PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE