Cruise SET Indicator Light Circuit: Procedure
WARNING: This page is about a different variant/trim than selected.
- PERFORM ACTIVE TEST USING TECHSTREAM
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Check the cruise control SET indicator light by performing the Active Test.COMBINATION METER
Tester Display Test Part Control Range Diagnostic Note Indicat. SET Cruise control SET indicator light Cruise control SET indicator light ON / OFF - OK
The cruise control SET indicator light goes on or goes off.
NG → See step 3
OK → See step 2
- REPLACE PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE
- REPLACE METER CIRCUIT PLATE NO. 3. Refer to DISASSEMBLY