DTC C1A10: Front Radar Sensor: Procedure

1. Replace the millimeter wave radar sensor assembly. Refer to REMOVAL .

NEXT: Go to next step 

1. Adjust the millimeter wave radar sensor assembly. Refer to ADJUSTMENT .

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Clear the DTCs. Refer to DTC CHECK / CLEAR .
4. Perform the following to make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the malfunction cannot be detected.

   1. Drive the vehicle at a speed for which radar cruise control operation is possible.
   2. Turn the cruise control system on using the cruise control switch (ON-OFF button).
   3. Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.
5. Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
6. Check for DTCs.

   Result

   Result	Proceed to
   DTC is not output	A
   DTC C1A10 is output	B

B → See step   4 

A → END