Wiper And Washer System: Precaution: Precaution
WARNING: This page is about a different variant/trim than selected.
NOTE:
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system(s) after the cable is reconnected:
| System | See Procedure |
|---|---|
| Power Door Lock Control System | Refer to INITIALIZATION |
- PRECAUTION OF WASHER NOZZLE ADJUSTMENT
- Do not clean or adjust the washer nozzle with a safety pin, etc. because;
- the washer nozzle tip is made of resin and could be damaged.
- adjustment is not necessary because the washer nozzle is a spray type. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.
- If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush, etc.
- Do not clean or adjust the washer nozzle with a safety pin, etc. because;