LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2013 >> Prius V >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control / Dynamic Control System (Service Information) >> Steering Angle Sensor >> Removal >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Angle Sensor: Removal: Removal

NOTE:
  • Do not remove the steering angle sensor from the spiral cable.
  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.
  1. REMOVE STEERING WHEEL ASSEMBLY 

    Refer to REMOVAL

  2. REMOVE STEERING COLUMN COVER  . Refer to REMOVAL - Step 5
  3. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY 
    1. Remove the spiral cable with sensor sub-assembly. Refer to REMOVAL - Step 3 .
      NOTE:
      • Do not replace the spiral cable with sensor sub-assembly with the negative (-) auxiliary battery cable connected and the power switch on (IG).
      • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the negative (-) auxiliary battery cable connected and the power switch on (IG).
      • Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
      • Do not remove the steering angle sensor from the spiral cable.
scientia non olet · About LEMON Manuals