Sound Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier [11/2013 - 10/2015]: Procedure

1. Disconnect the G141 navigation receiver assembly connector.
2. Disconnect the M22 stereo component amplifier assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   M22-5 (R+) - G141-1 (FR+)	Always	Below 1 Ω
   M22-4 (R-) - G141-5 (FR-)	Always	Below 1 Ω
   M22-3 (L+) - G141-2 (FL+)	Always	Below 1 Ω
   M22-2 (L-) - G141-6 (FL-)	Always	Below 1 Ω
   M22-6 (SLD) - Body ground	Always	10 kΩ or higher
   M22-5 (R+) - Body ground	Always	10 kΩ or higher
   M22-4 (R-) - Body ground	Always	10 kΩ or higher
   M22-3 (L+) - Body ground	Always	10 kΩ or higher
   M22-2 (L-) - Body ground	Always	10 kΩ or higher

   Result	Proceed to
   	OK
   	NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [11/2013 - 10/2015]  . 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR