Data List / Active Test
WARNING: This page is about a different variant/trim than selected.
- DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Main Body / Data List / All Data.
- According to the display on the Techstream, read the Data List.MAIN BODY
Tester Display Measurement Item/Range Normal Condition Diagnostic Note Communication D-Door Motor Connection status between front power window regulator motor assembly LH and main body ECU (instrument panel junction block assembly) / OK or STOP OK: Connection
STOP: No connectionWhen there is a malfunction, a DTC is stored. The Number of DTC Number of trouble codes / Min.: 0, Max.: 255 Number of stored DTCs - NOTE:When the Techstream display is changed to "All Data", items that are not applicable to the vehicle may be displayed.