Data List / Active Test

WARNING: This page is about a different variant/trim than selected.

READ DATA LIST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / D-Door Motor or Main Body / Data List.

Read the Data List according to the display on the Techstream.

D-DOOR MOTOR

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
D Door P/W Auto SW	Driver side power window auto switch signal / ON or OFF	ON: Driver side power window switch auto up/down operated OFF: Driver side power window switch auto up/down not operated	-
D Door P/W Up SW	Driver side power window switch manual up signal / ON or OFF	ON: Driver side power window switch manual up operated OFF: Driver side power window manual up switch not operated	-
D Door P/W Down SW	Driver side power window switch manual down signal / ON or OFF	ON: Driver side power window switch manual down operated OFF: Driver side power window switch manual down not operated	-
Number of Trouble Codes	Number of trouble codes / Min.: 0 or Max.: 255	Number of DTCs will be displayed	-

MAIN BODY

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
D Door Courtesy SW	Front door courtesy light switch LH / ON or OFF	ON: Front door LH open OFF: Front door LH closed	-
P Door Courtesy SW	Front door courtesy light switch RH / ON or OFF	ON: Front door RH open OFF: Front door RH closed	-
Communication D-Door Motor	Connection status between front power window regulator motor assembly LH and main body ECU (instrument panel junction block assembly) / OK or STOP	OK: Normal communication STOP: Communication stopped	-

ACTIVE TEST

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / D-Door Motor or Main Body / Active Test.

Perform the Active Test according to the display on the Techstream.

WARNING:

Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function will not operate.

D-DOOR MOTOR

Tester Display	Test Part	Control Range	Diagnostic Note
Power Window	Power window	OFF / UP / DOWN	-

HINT:

Up and down movement does not occur if the arrow is not pressed and held.

MAIN BODY

Tester Display	Test Part	Control Range	Diagnostic Note
IG OFF P/W Control Permission Output	Power window	OFF / ON	Perform this Active Test with the power switch off

HINT:

If Active Test is turned on, only the driver side power window does not operate.