Data List / Active Test
- DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Main Body / Data List.
- Read the Data List according to the display on the Techstream.MAIN BODY
Tester Display Measurement Item/Range Normal Condition Diagnostic Note Wireless Control Wireless door lock control function/ON or OFF ON: Operating
OFF: Not operating- Hazard Answer Back Hazard answer-back of wireless/ON or OFF ON: Operating
OFF: Not operating- Wireless Auto Lock Automatic lock function / ON or OFF ON: Operating
OFF: Not operating- Open Door Warning Open door warning/ON or OFF ON: Operating
OFF: Not operating- Unlock 2 Operation 2 times operation of wireless unlock / ON or OFF ON: All doors unlock when UNLOCK switch pressed twice
OFF: All doors unlock when UNLOCK switch pressed once- Panic Function Panic function/ON or OFF ON: Operating
OFF: Not operating- Auto Lock Time Automatic lock time/120 s, 60 s or 30 s 120 s: 120 seconds
60 s: 60 seconds
30 s: 30 seconds- Wireless Buzz Vol Wireless buzzer volume / LEVEL0 to LEVEL7 Level7: Biggest volume
Level6
Level5
Level4
Level3
Level2
Level1: Smallest volume
Level0: No sound-
- ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Main Body / Active Test.
- Perform the Active Test according to the display on the Techstream.MAIN BODY
Tester Display Test Part Control Range Diagnostic Note Illuminated Entry System Interior light and ignition key cylinder light (Interior light switch is in DOOR position and all doors are closed) ON/OFF - Hazard Turns the turn signal flasher relay ON/OFF Observe headlight and rear combination light for correct operation Security Horn Turns the security horns ON/OFF -