LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2013 >> Venza Limited, AWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Smart Key System (For Start Function) (Diagnostics - Introduction) >> SMART KEY SYSTEM (for Start Function) >> Customize Parameters >> Customize Parameters
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Customize Parameters

  1. CUSTOMIZING FUNCTION WITH TECHSTREAM 

    HINT: 

    The items in the table below can be customized.

    NOTE:
    • When the customer requests a change in a function, first make sure that the function can be customized.
    • Be sure to make a note of the current setting before customizing.
    • When troubleshooting a function, first make sure that the function is set to the default setting.
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Smart Key / Utility / Customize Setting.
    5. Select the setting by referring to the table below.
      SMART KEY

      Tester Display Default Content Setting
      Ignition Available Area (Entry ignition available area) ALL Function to choose the available area for electrical key to start the engine and cancel the steering lock. FRONT or ALL
      Key Low Battery Warning ON Function to warning driver that the key battery is low. ON or OFF
  2. CUSTOMIZING FUNCTION WITHOUT TECHSTREAM 

    Performing the following procedure disables the smart key system.

    HINT: 

    To start the engine while the smart key system is disabled, follow the procedure for when the key battery is low. Refer to SYSTEM DESCRIPTION .

    1. The operation procedures are as follows:

      Precondition:

      Engine switch off, driver side door closed and unlocked.

      1. Push the unlock switch of the key once.
      2. Open the driver door within 5 seconds.
      3. Push the unlock switch of the key twice within 5 seconds.
      4. Close and open the driver door twice within 30 seconds.

        (Driver door: Close → Open → Close → Open)

      5. Push the unlock switch of the key twice within 5 seconds.
      6. Close and open the driver door within 30 seconds.

        (Driver door: Close → Open)

      7. Close the driver door within 5 seconds.

        When electrical key cancel is activated, the wireless door lock buzzer sounds twice.

        To return to the original condition, perform the procedures again. When the original condition is returned, the wireless door lock buzzer sounds once.