Yaw Rate And Acceleration Sensor: Installation: Installation

WARNING: This page is about a different car, the 2013 Toyota Prius V. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL YAW RATE AND ACCELERATION SENSOR
1. Install the yaw rate and acceleration sensor with the 2 bolts.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  NOTE:
  - Do not damage the yaw rate and acceleration sensor.
  - Make sure that the yaw rate and acceleration sensor is installed securely.
  - Do not use dropped or damaged parts.
  - Keep the contact surfaces of the yaw rate and acceleration sensor and the body free of foreign matter.
  - Make sure that the sensor is facing the correct direction.
2. Connect the yaw rate and acceleration sensor connector.
  NOTE:
  Make sure that the yaw rate and acceleration sensor connector is connected securely.
INSTALL CONSOLE BOX ASSEMBLY
Refer to INSTALLATION
CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL
Refer to INSTALLATION - Step 2
PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
Refer to CALIBRATION