LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2014 >> Corolla L, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Immobilizer System (W/ Smart Key) - Diagnostics - Introduction (Model Code: ZRE172) >> IMMOBILIZER SYSTEM (W/ Smart Key System) >> DTC Check / Clear [08/2013 - ] >> DTC Check / Clear [08/2013 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Check / Clear [08/2013 - ]

NOTE:

When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.

HINT: 

Refer to the Techstream operator's manual for further details.

  1. CHECK FOR IMMOBILIZER DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

      Body Electrical > Smart Key > Trouble Codes 

    5. Check for DTCs.
  2. CHECK FOR ECM DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

      Powertrain > Engine and ECT > Trouble Codes 

    5. Check for DTCs.
  3. CLEAR IMMOBILIZER DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

      Body Electrical > Smart Key > Clear DTCs 

    5. Clear the DTCs.
  4. CLEAR ECM DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

      Powertrain > Engine and ECT > Clear DTCs 

    5. Clear the DTCs.
scientia non olet · About LEMON Manuals