DTC P0575: Cruise Control Input Circuit [08/2013 - 08/2016]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [08/2013 - ]

   Powertrain > Cruise Control > Clear DTCs 

5. Perform the following to make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the malfunction cannot be detected.

   1. Drive the vehicle at a speed for which cruise control operation is possible.
   2. Turn the cruise control system on using the cruise control main switch (ON-OFF button).
   3. Push the cruise control main switch to -/SET to begin control of vehicle speed using the cruise control system.
6. Check for DTCs.

   Refer to DTC CHECK / CLEAR [08/2013 - ]

   Powertrain > Cruise Control > Trouble Codes 

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result:  1

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2013 - 04/2014]  Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [04/2014 - 08/2016] 

Result:  2

B 

REPLACE ECM 

for 2ZR-FAE: Refer to COMPONENTS [08/2013 - 08/2016]

for 2ZR-FE: Refer to COMPONENTS [08/2013 - 08/2016]