LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2014 >> Corolla L, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transaxle (Service Information) (Model Code: ZRE172)) >> Shift And Select Lever Shaft >> Reassembly [08/2013 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Reassembly [08/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL SELECT STOPPER BLOCK 
    1. Coat the select stopper block with gear oil.
    2. Install the select stopper block as shown in the illustration.
      GTY436271Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Confirm the installation direction.

    3. Using a 5 mm pin punch and a hammer, install the slotted spring pin to the shift and select lever shaft.
      GTY452487Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Depth

      Standard Depth

      -0.2 to 0.8 mm (-0.00787 to 0.0315 in.)

  2. INSTALL RELEASE HEAD STRAIGHT PIN 
    1. Install the release head straight pin to the select stopper block.
      GTY455234Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Coat the release head with gear oil.
    3. Install the release head as shown in the illustration.
      GTY425101Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Confirm the installation direction.

    4. Install the release head torsion spring as shown in the illustration.
      NOTE:

      Confirm the installation direction.

      GTY447761Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Hook
      *b Hook Side
      *c 14.5 to 15.5 mm (0.571 to 0.610 in.)
      *d 8.3 to 9.3 mm (0.327 to 0.366 in.)
    5. Coat the front inner shift lever with gear oil.
    6. Install the front inner shift lever as shown in the illustration.
      GTY446128Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Confirm the installation direction.

      HINT: 

      Insert the release head torsion spring into the installation hole of the front inner shift lever.

    7. Turn the front inner shift lever counterclockwise to align it with the installation surface of the release head straight pin, and install it.
      GTY446160Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Release Head Torsion Spring
      *2 Release Head Straight Pin
      NOTE:

      Confirm that the front inner shift lever is installed as shown in the illustration.

    8. Using a 5 mm pin punch and a hammer, install the slotted spring pin to the shift and select lever shaft.
      GTY435839Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Depth

      Standard Depth

      -0.2 to 0.8 mm (-0.00787 to 0.0315 in.)

  3. INSTALL INNER NO. 2 SHIFT LEVER 
    1. Coat the inner No. 2 shift lever with gear oil.
    2. Using a 5 mm pin punch and a hammer, install the inner No. 2 shift lever and slotted spring pin to the shift and select lever shaft.
      GTY426198Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Depth

      Standard Depth

      0 to 0.6 mm (0 to 0.0236 in.)

      NOTE:

      Confirm the installation direction.

scientia non olet · About LEMON Manuals