Front Passenger Side Seat Belt Warning Light Malfunction [04/2014 - 08/2017]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. Read the Data List according to the display on the Techstream.

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   P-Seatbelt Buckle SW	Front passenger seat belt buckle switch	ON or OFF	ON: Front passenger seat belt fastened OFF: Front passenger seat belt unfastened	The front passenger seat is occupied

   Body Electrical > Combination Meter > Data List 

   Tester Display
   P-Seatbelt Buckle SW

   OK

   The Techstream display changes correctly in response to the front passenger seat belt condition.

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [08/2013 - 08/2016]  Refer to  REMOVAL [08/2016 - ] 

Result:  2

NG 

See step  2

1. Remove the occupant detection sensor (separate type front seat cushion pad).

   Refer to REMOVAL [04/2014 - 08/2017]

2. Inspect the occupant detection sensor (separate type front seat cushion pad).

   Refer to INSPECTION [04/2014 - 08/2017]

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

REPLACE OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD). Refer to  REMOVAL [04/2014 - 08/2017] 

Result:  1

OK 

See step  3

1. Remove the front seat inner belt assembly RH.

   Refer to REMOVAL [04/2014 - 08/2014] Refer to REMOVAL [08/2014 - 08/2016] Refer to REMOVAL [08/2016 - 08/2017]

2. Inspect the front seat inner belt assembly RH.

   Refer to INSPECTION [04/2014 - 08/2016] Refer to INSPECTION [08/2016 - 08/2017]

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

REPLACE FRONT SEAT INNER BELT ASSEMBLY RH. Refer to  REMOVAL [04/2014 - 08/2014]  Refer to  REMOVAL [08/2014 - 08/2016]  Refer to  REMOVAL [08/2016 - 08/2017] 

Result:  1

OK 

See step  4

1. Disconnect the E43 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E43-7 (P/SB) - L55-3 (+)	Always	Below 1 Ω
   E43-7 (P/SB) - Body ground	Always	10 kΩ or higher
   L55-3 (+) - Body ground	Always	10 kΩ or higher
   L55-2 (E) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [08/2013 - 08/2016]  Refer to  REMOVAL [08/2016 - ] 

Result:  2

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR