DTC P2610: ECM / PCM Internal Engine Off Timer Performance [08/2016 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REPLACE ECM
- Replace the ECM.
Refer to REMOVAL [08/2016 - ]
Result
Proceed to NEXT
Result: 1
NEXT
See step 2
- Replace the ECM.
- CHECK WHETHER DTC OUTPUT RECURS (DTC P2610)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Clear the DTCs.
Refer to DTC CHECK / CLEAR [08/2013 - ]
Powertrain > Engine and ECT > Clear DTCs
- Turn the ignition switch off and wait for at least 30 seconds.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Pending.
Powertrain > Engine and ECT > Trouble Codes
- If no pending DTC is output, the repair has been successfully completed.
Result
Proceed to NEXT
Result: 1
NEXT
END