Precaution [08/2013 - 08/2016]
- PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the cable is reconnected.
System Name See Procedure Air Conditioning System (for Automatic Air Conditioning System) Refer to INITIALIZATION [08/2013 - 08/2015] Refer to INITIALIZATION [08/2015 - 08/2016] - IGNITION SWITCH EXPRESSIONS
- The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression Ignition Switch (Position) Engine Switch (Condition) Ignition Switch off LOCK Off (Lock) Ignition Switch ACC ACC On (ACC) Ignition Switch ON ON On (IG) Engine Start START On (Start)
- The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
- POWER WINDOW CONTROL SYSTEM PRECAUTIONS NOTE:
- The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2013 - 08/2016]
- The power window control system prohibits the auto up and down function when the jam protection function malfunctions.
- If the power window regulator motor assembly (for driver door) has been replaced with a new one, initialize the power window control system.
- If the power window regulator motor assembly (for driver door) and door window regulator sub-assembly have been removed and installed, or if the power window regulator motor assembly (for driver door) was reused when the door glass or door glass run was replaced, initialize the power window control system.
- The jam protection function may operate unexpectedly, even when the power window control system is normal, due to detection of a value different than the operation learned value when the door glass moving speed changes sharply under any of the following conditions:
- A power window is being opened or closed while the vehicle is driven on a rough road.
- A power window is being opened or closed while the door is being opened or closed.
- The voltage changes abruptly.
- Do not disconnect the battery while the ignition switch is ON. Otherwise, DTC B2313 will be stored.
Refer to DTC B2313: Glass Position Initialization Incomplete [08/2013 - ]
- The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.