Skid Control Buzzer: Installation: Installation

WARNING: This page is about a different car, the 2013 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL SKID CONTROL BUZZER ASSEMBLY
1. Connect the buzzer connector.
  
  Fig 1: Identifying Skid Control Buzzer Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Securely connect the connector.
2. Attach the clamp to install the buzzer.
  NOTE:
  - Securely insert the clamp into the bracket.
  - If the buzzer is dropped, replace it.
INSTALL NO. 1 SWITCH HOLE BASE . Refer to INSTALLATION - Step 30
INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL . Refer to INSTALLATION - Step 31
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 33
INSTALL COWL SIDE TRIM BOARD LH . Refer to INSTALLATION - Step 32
INSTALL FRONT DOOR SCUFF PLATE LH . Refer to INSTALLATION - Step 75
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .