DTC U0100-530: Lost Communication with ECM / PCM "A"; DTC U0129-527: Lost Communication with Brake System Control Module; DTC U0129-528: Lost Communication with Brake System Control Module; DTC U0140-146: Communication Error from Body ECU to HV ECU; DTC U0151-763: Communication Error from Airbag ECU to HV ECU; DTC U0164-827: Communication Error from A/C ECU to HV ECU; DTC U1107-436: Lost Communication with Power Management Module [12/2013 - ]: Procedure
- CHECK DTC OUTPUT (HEALTH CHECK)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON (IG).
- Enter the following menus: System Select / Health Check.
- Check if DTCs are output.
Result
Result Proceed to Power management control ECU outputs P2532-772 A Power management control ECU does not output P2532-772 B - Turn the ignition switch off.
B → See step 2
A → See step 3
- GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2013 - ]
- GO TO DTC CHART (P2532-772). Refer to DTC P2532-772: Ignition Switch Run Position Circuit High [12/2013 - ]