Inspection Procedure
NOTE:
- When using the Techstream with the power switch off, perform either of the following: 1) Turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and vehicle begins, or 2) connect the Techstream to the vehicle, select the vehicle type under manual mode, and then enter the following menus:
for Power Source Control: Body Electrical / Power Source Control / DTC.
for Smart Key: Body Electrical / Smart Key / DTC.
- The smart key system (for Start Function) uses a multiplex communication system (LIN communication system) and the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2013 - ] . Troubleshoot the smart key system (for Start Function) after confirming that the communication systems are functioning properly.
- Make sure that no DTCs are output. If any DTCs are output, proceed to the Diagnostic Trouble Code Chart. Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2013 - ] .
- If the smart key system is disabled through the customize function, enable the system before performing troubleshooting. Refer to CUSTOMIZE PARAMETERS [12/2013 - ] .
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- After completing repairs, confirm that the problem does not occur.
HINT:
RELATED DATA LIST AND ACTIVE TEST ITEMS
| Problem Symptom | Data List Item | Active Test Item |
|---|---|---|
| Power source mode does not change to on (ACC) but does change to on (IG) | Power Source Control
|
- |