LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2014 >> Prius C Two >> Repair and Diagnosis (Single Page) >> Hybrid/Electric Powertrain >> Testing and Diagnosis >> Hybrid Control System (Diagnostic Codes (P0069-273 - P0A75-336)) >> Hybrid Control System >> DTC P0A1A-200: Generator Control Module; DTC P0A1A-792: Generator Control Module; DTC P0A1A-793: Generator Control Module [12/2013 - ] >> Confirmation Driving Pattern
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Confirmation Driving Pattern

Fig 1: Identifying Power Switch / Scantool Operation Graph
GTY443495Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Connect the Techstream to the DLC3.
  2. Turn the ignition switch to ON (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the ignition switch off and wait for 30 seconds or more.
  5. Turn the ignition switch to ON (IG) and wait for 5 seconds or more.
  6. Turn the ignition switch to ON (READY) with the shift lever in P and wait for 5 seconds or more.
  7. Depress the accelerator pedal of the vehicle with the engine stopped and the shift lever in P to start the engine.
  8. Keep the engine running for 5 seconds or more.
  9. Drive the vehicle forward with the shift lever in D for 5 m or more. [A]
  10. Drive the vehicle backward with the shift lever in R for 5 m or more. [B]
  11. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes. [C]
  12. Read the current DTCs.

    HINT: 

    • If a current DTC is output, the system is malfunctioning.
    • If a current DTC is not output, perform the following procedure.
  13. Check that permanent DTCs are cleared. If no permanent DTC is output, the system is normal.
  14. If the permanent DTCs are not cleared, perform the universal trip, and then check for permanent DTCs again.
scientia non olet · About LEMON Manuals