Installation [10/2013 - ]

WARNING: This page is about a different variant/trim than selected.

INSTALL KNOCK SENSOR
HINT:

Perform "Inspection After Repair" after replacing the knock sensor. Refer to INITIALIZATION [10/2013 - ] .
1. Install the knock sensor with the bolt as shown in the illustration.
  
  Fig 1: Installing Knock Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
  
  NOTE:
  Make sure that the knock sensor is in the correct position.
2. Connect the knock sensor connector.
INSTALL INTAKE MANIFOLD
1. Install the intake manifold. Refer to INSTALLATION [10/2013 - ] .
PERFORM INITIALIZATION
1. Perform "Inspection After Repair" after replacing the knock sensor. Refer to INITIALIZATION [10/2013 - ] .