LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2014 >> Prius Four >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 69 (Power Distribution (Service Information) (Plug-In)) >> Power Management Control Ecu >> Installation [10/2013 - ] >> Installation [10/2013 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation [10/2013 - ]

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL POWER MANAGEMENT CONTROL ECU 
    1. Engage the 2 claws to install the power management control ECU.
  2. INSTALL ECU INTEGRATION BOX 
    1. Install the ECU integration box with the 2 nuts and bolt.

      Nut 

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

      Bolt 

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

    2. Engage the 3 clamps to connect the wire harness.
    3. Connect each connector.
  3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY  . Refer to INSTALLATION [10/2013 - ] - Step 12
  4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  . Refer to INSTALLATION [10/2013 - ] - Step 13
  5. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [10/2013 - ] .

  6. INSTALL DECK FLOOR BOX RH  . Refer to INSTALLATION [10/2013 - ] - Step 54
  7. INSTALL REAR NO. 3 FLOOR BOARD  . Refer to INSTALLATION [10/2013 - ] - Step 55
  8. INSTALL REAR NO. 2 FLOOR BOARD  . Refer to INSTALLATION [10/2013 - ] - Step 56
scientia non olet · About LEMON Manuals