LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2014 >> Prius Three >> Repair and Diagnosis (Single Page) >> External Pages >> Different variant/trim >> Section 11 (Lighting System (Interior) (Diagnostics & Circuit Tests) (Plug-In)) >> Lighting System >> Customize Parameters [10/2013 - ] >> Customize Parameters [10/2013 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Customize Parameters [10/2013 - ]

WARNING: This page is about a different variant/trim than selected.
  1. CUSTOMIZE LIGHTING SYSTEM (INT) 
    1. Customizing using the Techstream

      HINT: 

      The following items can be customized.

      NOTE:
      • When the customer requests a change in a function, first make sure that the function can be customized.
      • Be sure to make a note of the current settings before customizing.
      • When troubleshooting a function, first make sure that the function is set to the default setting.
      1. Connect the Techstream to the DLC3.
      2. Turn the power switch on (IG).
      3. Turn the Techstream on.
      4. Enter the following menus: Customize Setting / Illuminated Entry.
      5. Select the setting by referring to the table below.
        ILLUMINATED ENTRY

        Tester Display Default Content Setting Relevant ECU
        Lighting Time 15 s Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (ACC or IG).) 15 s, 7.5 s or 30 s Main body ECU (Multiplex network body ECU)
        I/L when ACC OFF ON Lights up power switch illumination, front interior lights and rear interior light when the power switch is turned from on (ACC or IG) to off. OFF or ON
        I/L ON W/Door Key Unlock ON Lights up power switch illumination, front interior lights, rear interior light and footwell lights when doors are unlocked using a mechanical key or door control transmitter. OFF or ON
        Room Light when Aprchd ON Lights up the power switch illumination, front interior lights and rear interior light when a key enters any actuation area around the doors. OFF or ON
        Inside Foot Light*1 ON ON/OFF of footwell light control function. OFF or ON
        Light Control*1 ON Dims (ON setting) or turns off (OFF setting) the footwell lights under the following conditions:
        • Power switch on (READY), shift state other than park (P) has been selected, and all doors closed.
        OFF or ON
        Interior Light Control ON Lights up the power switch illumination, front interior light, rear interior light and footwell lights when the illuminated entry function is operating. OFF or ON
        • *1: w/ Footwell Light
    2. Customizing with the Multi-display (for Navigation Receiver Type)
      1. Turn the power switch on (IG).
      2. Enter the following menus: Setup / Vehicle / Vehicle Customization / Light Settings
      3. Select the setting by referring to the table below
        Display Default Content Setting Relevant ECU
        Interior Lights Off Timer 15 sec. Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (ACC or IG).) Off, 7.5 sec., 15 sec., or 30 sec. Main body ECU (Multiplex network body ECU)