Precaution [10/2013 - ]
- PRECAUTION WHEN REMOVING/INSTALLING INVERTER WITH CONVERTER ASSEMBLY WARNING:
Be careful not to injure yourself on the edges of the inverter with converter assembly when performing work.
NOTE:Observe the following in order to prevent entry of foreign matter:
- Do not allow foreign matter such as grease, oil or water to adhere to the inside of the inverter with converter assembly.
- Do not use air tools in areas other than specified to prevent entry of dust.
- Prevent wind from blowing through the workshop to prevent entry of dust.
- Do not drop any bolts or tools into the inverter with converter assembly.
- Clean the tools before use.
NOTE:PRECAUTION WHEN HANDLING ELECTRONIC COMPONENTS
- Do not touch any connector terminals or circuit boards, as static electricity may be applied to the internal circuits.
- Do not drop electronic components such as circuit boards or subject them to impact.
- Keep the removed parts free from dust.
- Electronic components are very sensitive. Be sure to observe the handling instructions.
NOTE:PRECAUTION WHEN HANDLING PARTS
- Do not drop parts or subject them to impact.
- Be sure to observe the handling instructions to prevent parts from being damaged.
NOTE:PRECAUTION WHEN SUSPENDING WORK
- If suspending work, cover parts with clean pieces of paper to prevent entry of dust and foreign matter.
HINT:
- Arrange the removed parts in the correct order so that they can be installed to the correct position and with the correct orientation.
- It is recommended to take pictures of parts before removing them to ensure correct installation.