Installation [10/2013 - ]

WARNING: This page is about a different variant/trim than selected.

INSTALL ENGINE COOLANT TEMPERATURE SENSOR
HINT:

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor. Refer to INITIALIZATION [10/2013 - ] .
1. Install a new gasket to the engine coolant temperature sensor.
2. Using a union nut wrench 19 mm, install the engine coolant temperature sensor.
  Torque: 20 N*m (200 kgf*cm, 14 ft.*lbf)
  
  NOTE:
  Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench. Refer to PRECAUTION [10/2013 - ] .
3. Connect the engine coolant temperature sensor connector.
INSTALL INVERTER RESERVE TANK ASSEMBLY See step 2
INSTALL FUEL INJECTOR ASSEMBLY
Refer to INSTALLATION [10/2013 - ] .
ADD COOLANT (for Engine) . Refer to REPLACEMENT [10/2013 - ] - Step 2
INSPECT FOR COOLANT LEAK (for Engine) . Refer to ON-VEHICLE INSPECTION [10/2013 - ] - Step 1
INSPECT FOR FUEL LEAK . Refer to ON-VEHICLE INSPECTION [10/2013 - ] - Step 1
PERFORM INITIALIZATION
1. Perform "Inspection After Repair" after replacing the engine coolant temperature sensor. Refer to INITIALIZATION [10/2013 - ] .