LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2014 >> Prius Two >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Smart Key System (For Start Function) (Diagnostic Codes & Symptom Tests) (Except Plug-In) >> SMART KEY SYSTEM (for Start Function) >> DTC B2286: Runnable Signal Malfunction [10/2013 - ] >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

NOTE:
  • When the power management control ECU is replaced with a new one and the cable from the negative (-) auxiliary battery terminal is connected, the power source mode becomes on (IG) mode. When the auxiliary battery is removed and reinstalled, the power source mode that was selected when the auxiliary battery was removed is restored.
  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT: 

Check the connector connection to the terminal to make sure that there is no abnormality such as a loose connection, deformation, etc.

scientia non olet · About LEMON Manuals