Typical Enabling Conditions
ALL
| Monitor runs whenever following DTCs are not present | None |
| All of the following conditions are met | - |
| Auxiliary battery voltage | 8 V or more |
| Power switch | On (IG) |
| Time after power switch off to on (IG) | More than 0.5 seconds |
P261B: ENGINE WATER PUMP CIRCUIT PERFORMANCE
| All of the following conditions are met | - |
| Output duty cycle | 40% or more |
| Monitor synchronism monitor status | Enable |
| Engine coolant temperature | -10°C (14°F) or more |
| Engine coolant temperature sensor circuit fail (P0115, P0117, P0118) | Not detected |
| Engine water pump circuit low voltage fail (P261C) | Not detected |
| Engine water pump circuit high voltage fail (P261D) | Not detected |
P261C AND P261D: ENGINE WATER PUMP CIRCUIT RANGE CHECK (LOW VOLTAGE, HIGH VOLTAGE)
| All of the following conditions are met | - |
| Output duty cycle | 40 to 60% |
| Engine water pump circuit performance fail (P261B) | Not detected |
| Engine water pump output terminal voltage monitor counter | 0.08 seconds or more |