DTC B2284: Brake Signal Malfunction [10/2013 - ]: Procedure

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR (AUXILIARY BATTERY - POWER MANAGEMENT CONTROL ECU) 

OK: Go to next step 

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY GROUND) 

OK: Go to next step 

1. Disconnect the A88 connector from the stop light switch assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the voltage and resistance according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   A88-1 (B) - A88-3 (GND)	Always	11 to 14 V

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A88-3 (GND) - Body ground	Always	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Stop Light Switch Assembly)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Reconnect the A88 connector to the stop light switch assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   A88-2 (L) - A88-3 (GND)	Power switch off, brake pedal not depressed	Below 1 V
   A88-2 (L) - A88-3 (GND)	Power switch off, brake pedal depressed	11 to 14 V

   TEXT IN ILLUSTRATION
   
   

   *a	Component with harness connected (Stop Light Switch Assembly)

NG → REPLACE STOP LIGHT SWITCH ASSEMBLY 

OK: Go to next step 

1. Disconnect the A86 connector from the power management control ECU.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A86-23 (STP) - A88-2 (L)	Always	Below 1 Ω
   A86-23 (STP) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - POWER MANAGEMENT CONTROL ECU) 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Power Source Control / Data List.
5. Read the Data List according to the display on the Techstream.
   POWER SOURCE CONTROL
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Specified Condition
   Stop Light Switch1	Stop light switch1/ON or OFF	ON: Brake pedal depressed OFF: Brake pedal released	-

   OK

   ON (brake pedal is depressed) and OFF (brake pedal is released) appear on the screen.

NG → See step   7 

OK → See step   8