Installation [10/2013 - ]

WARNING: This page is about a different variant/trim than selected.

HINT:

Although the part name refers to the No. 1 crank position sensors, this procedure is for the camshaft position sensors.

INSTALL NO. 1 CRANK POSITION SENSOR
1. Apply a light coat of engine oil to the O-rings on the No. 1 crank position sensors.
  
  Fig 1: Identifying O-Ring On Camshaft Position Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the No. 1 crank position sensor with the bolt.
  
  Fig 2: Identifying No. 1 Crank Position Sensor Connector & Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
3. Connect the No. 1 crank position sensor connector.
INSPECT FOR OIL LEAK
INSTALL NO. 2 CYLINDER HEAD COVER . Refer to INSTALLATION [10/2013 - ] - Step 99