DTC P3193: Fuel Run Out [10/2013 - ]: Procedure

1. Check the amount of fuel remaining.

   OK

   There is enough fuel.

   HINT: 

   • DTCs P3190, P3191 and/or P3193 may be output if the vehicle ran out of fuel in the past.
   • If not enough fuel is added, DTC P3190, P3191 or P3193 may be output again. If the engine cannot be started because the vehicle is out of fuel, add fuel until the fuel level warning light turns off.

   Result

   Result	Proceed to
   NG	A
   OK	B

B → See step   3 

A: Go to next step 

1. Add fuel until the fuel level warning light turns off.

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs. Refer to DTC CHECK / CLEAR [10/2013 - ] .
5. Turn the power switch off and wait for at least 30 seconds.
6. Turn the power switch on (READY).
7. Turn the Techstream on.
8. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
9. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Pending.
10. Read the pending DTCs.
    RESULT
    
    

    Result	Proceed to
    DTC is not output	A
    DTC P3190 or P3191 is output	B
    DTC P3190 or P3191 and other DTCs are output	C

B → See step   4 

C → See step   5 

A → END