LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2014 >> Prius Two >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 134 (Pre-Collision System (Diagnostics - Introduction) (Plug-In)) >> Pre-Collision System >> DTC Check / Clear [10/2013 - ] >> DTC Check / Clear [10/2013 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Check / Clear [10/2013 - ]

WARNING: This page is about a different variant/trim than selected.
  1. CHECK DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Pre-Collision / Trouble Codes.
    5. Enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
    6. Check the details of the DTC(s). Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2013 - ] .

    HINT: 

    As the driving support ECU and seat belt control ECU output DTCs for the pre-collision system, be sure to check the Pre-Collision and Pre-Collision 2 DTCs.

  2. CLEAR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Pre-Collision / Trouble Codes.
    5. Enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
    6. Clear the DTCs.

    HINT: 

    As the driving support ECU and seat belt control ECU output DTCs for the pre-collision system, be sure to clear the Pre-Collision and Pre-Collision 2 DTCs.

scientia non olet · About LEMON Manuals