DTC P0111: Intake Air Temperature Sensor Gradient Too High [10/2013 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0111)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs.RESULT
Result Proceed to DTC P0111 and other DTCs are output A DTC P0111 is output B HINT:
- If any DTCs other than P0111 are output, troubleshoot those DTCs first.
- Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly. Refer to INITIALIZATION [10/2013 - ] .
B → See step 3
A → See step 2
- GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2013 - ]
- REPLACE MASS AIR FLOW METER SUB-ASSEMBLY. Refer to REMOVAL [10/2013 - ]