LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2014 >> RAV4 EV >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Smart Key System (Keyless Entry) (Diagnostic Codes & Symptom Tests) (Electric) >> Smart Key System (For Entry Function) >> Symptom Tests >> All Door Entry Lock and Unlock Functions do not Operate [09/2013 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

All Door Entry Lock and Unlock Functions do not Operate [09/2013 - ]: Procedure

  1. CHECK FOR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG) and turn the Techstream on.
    3. By following the Techstream screen display, check whether any DTCs are output.

      OK

      DTC is not output.

    NG → Go to CORRESPONDING SYSTEM 

    OK: Go to next step 

  2. CHECK POWER DOOR LOCK CONTROL SYSTEM 
    1. Check that the power door lock functions operate normally. Refer to OPERATION CHECK [09/2013 - ] .

      OK

      All doors can be locked and unlocked with door control switch.

    NG → See step   8 

    OK: Go to next step 

  3. CHECK WIRELESS DOOR LOCK CONTROL SYSTEM 
    1. Check that the wireless door lock functions operate normally. Refer to OPERATION CHECK [09/2013 - ] .

      OK

      Wireless door lock functions operate normally.

    NG → See step   7 

    OK: Go to next step 

  4. CHECK ELECTRICAL KEY TRANSMITTER SUB-ASSEMBLY (OPERATION) 
    1. Temporarily replace the electrical key transmitter sub-assembly with a new or normally functioning one.
    2. Check that the entry lock and unlock functions operate normally. Refer to OPERATION CHECK [09/2013 - ] .

      OK

      Entry lock and unlock functions operate normally.

    NG → See step   5 

    OK → END (ELECTRICAL KEY TRANSMITTER SUB-ASSEMBLY WAS DEFECTIVE) 

  5. READ VALUE USING TECHSTREAM (DOOR COURTESY LIGHT SWITCH) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Main Body / Data List.
    5. Read the Data List according to the display on the Techstream.
      MAIN BODY

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      D Door Courtesy SW Driver side door courtesy light switch signal / ON or OFF ON: Driver side door is open
      OFF: Driver side door is closed
      -
      P Door Courtesy SW Passenger side door courtesy light switch signal / ON or OFF ON: Passenger side door is open
      OFF: Passenger side door is closed
      -
      RL Door Courtesy SW Rear door LH courtesy light switch signal / ON or OFF ON: Rear door LH is open
      OFF: Rear door LH is closed
      -
      RR Door Courtesy SW Rear door RH courtesy light switch signal / ON or OFF ON: Rear door RH is open
      OFF: Rear door RH is closed
      -

      OK

      On Techstream screen, items change between ON and OFF according to above chart.

    NG → See step   9 

    OK → See step   6 

  6. REPLACE CERTIFICATION ECU (ECU AGGREGATION BOX ASSEMBLY). Refer to  REMOVAL [09/2013 - ] 
  7. Go to WIRELESS DOOR LOCK CONTROL SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2013 - ] 
  8. Go to POWER DOOR LOCK CONTROL SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2013 - ] 
  9. Go to LIGHTING SYSTEM. Refer to  Door Courtesy Switch Circuit [09/2013 - ]